1 position adjustment: hold head position control handle, the air spring to lift the self-locking, the piston rod extends, while driving head of bed rises slowly rise to the needed angle, loosen the handle, the bed surface is locked in the same position; hold the handle and the downward force decreased; big leg bed the lifting handle from the thigh position control; foot bed lifting by the foot control handle, when the grip, the pull pin is disengaged from the positioning hole, by weight dropped to a required angle, loosen the handle foot bed 12 is locked in position by hand; coordinated control and handle, a patient can be obtained from the semi procumbent to lie, curved legs, flat seat, sitting posture of various. In addition, the patient in the supine condition, to the side, the side of the small bed pulled out, turned down the side rails, a hand pressing bed outside the control button, the lateral lift gas spring self-locking, a piston rod extends out of the lateral bed, while driving slowly rise, rise to the required angle, release the control button is locked in the bed position, lateral position from the surface finish. Note: the same operation is used in reverse.
2, use the device solution: clockwise rotation solutions will handle, Kong Gai will open automatically, at the same time the toilet carrier along the transverse direction is automatically sent to the patient buttock, patients can lower the size of cleaning or counterclockwise rotation, the solution to handle, then Kong Gai closed and bed held flush bedpan is automatically sent to the operator one side at the same time, so that the nursing staff take cleaning, cleaning the bedpan back into the bedpan carrier, to prepare for the next use.
3, nursing bed guardrail grip horizontal side guardrail top edge, vertical upward about 20 mm, turn down 180 degrees, you can put down the fence, the patient bed, will flip up guardrail after 180 degrees, the vertical press can complete side guardrail rises. Note: the use of foot guardrails is the same.
4, the use of the living table: the opening of the plastic parts on the back of the living table is aimed at the upper side of the side guardrail, and can be pressed down. One hand presses the guardrail with one hand, and the other hand upwards the life table, which can be unloaded.
5, the bed infusion hanger: no matter in any state, can use the infusion stand, use infusion stand, the first two sections of the transfusion frame into a screw, and the transfusion frame below the hook at the top of the horizontal tube and the hook head above the alignment hole side guardrail tube pressure is above use up or remove the infusion hanger.
6, the use of brake lock: the brake when the brake is pressed with feet or under the hands, and the lifting is loosened.
7, the use of seat belts: when a patient uses the bed or needs to change his position, he must fasten his seat belt (the tightness of the seat belt is adjusted according to the individual's difference) so as to prevent danger.
8 feet, the operation of the device: when the level of foot bed, a thigh adjustment handle, lift the thigh bed surface, to prevent the patient fall; hold the foot position control handle, the foot bed in the appropriate position, turn down the foot board, then shake the handle to a thigh foot activity board level, put the basin to the feet. When the foot is washed, take the sewer basin and reset the foot moving plate to the original place. Hold the foot control handle and lift the foot bed to the horizontal position.